Technical data
Switching distance Sn*: 10 mm Idle current I0: ≤ 15 mA
Secured switching distance Sa*: ≤ (0,9 x Sn) mm Residual current: ≤ 0,1 mA
Sheet thickness: 0,6...2,5 mm Insulation test voltage: ≤ 0,5 kV
Hysteresis: 3…20 % Short circuit protection: yes / clock pulse
Ambient temperature: 0…+60 °C Current drop at Ie: ≤ 1,8 V
Temperature gradient: ≤ 0,4 K/min Wire breakage / reverse polarity
protection:
yes / complete
Storage temperature: -25…+80 °C
Operating voltage: 10…30 VDC Communication protocol: IO-Link
Residual ripple: ≤ 10 % Uss Output function: 4 wire, normally open, PNP
Signal delay: ≤ 180 ms Output 1: switching output or IO-Link mode
Standby delay: 300 ms Output 2: switching output
Operating current Ie: ≤ 100 mA
*The given switching distances are valid if the installation instructions are observed and a ferritic steel sheet with a sheet thickness of min. 0,8 mm to
max. 2,5 mm and a size of min. 50 x 50 mm is used.
Other parameters can cause a reduction of the switching distances or incorrect function of the sensor!
IO-Link
IO-Link specification: V 1.1 Frame type: 2.2
IO-Link port type: Class A Minimum cycle time: 8 ms
Communication mode: COM 2 (38,4 kBaud) Function pin 4: IO-Link
Process data width: 8 bit Function pin 2: DI
Switching point information: 2 bit Maximum cable length: 20 m
Status bit information: 5 bit Included in SIDI GSML: ja
Technical data
Electrical connection: connector, M12 x 1 Vibration resistance: 55 Hz (1 mm)
Cable: ? 5,2 mm, white, D12YSL9Y-OB,
PP, 0,2 m, halogen-free
Shock resistance: 30 g (11 ms)
Protection class: IP69K, except in the connector area
Wire cross-section: 4 x 0,34 mm2 Operating voltage display: LED
Material
Body material (introducer): steel
Body material (sensor): composite